![]() There's plenty of room for the factory single exhaust, and the rear axle is miles away from the back of the tank, so if we ever do get a wild itch to add 1-ton axles or huge dual exhaust in this Jeep we know we won't have to make fuel tank modifications to accomplish it. The way I bypassed it is much easier and simpler than the ways I’ve seen some guys doing it before. But until then, we have the tank up and held in place with four of the eight mounting holes, and we're pleased to say the fit is perfect with no interference at the bottom of the floor. 30 Location Yucaipa, CA 1 I've had my EVAP/ Charcoal Canister bypassed for some time now and just barely bulled the Charcoal Canister out so I thought I'd share how I did it. We'll have to drop the tank one more time to finish hooking up our fuel system after the engine swap begins, so we're going to wait until that time to hook up the filler and vent as well as welding the nuts to the inside of the frame to make install and removal much easier. Then, we pulled the tank back out and finished drilling the holes and then bolted the tank back in. Once it was up tight into place, we measured each side to make sure the tank was centered side to side and from the rear crossmember and then drilled eight small pilot holes through the frame at the center of each tank bracket. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |